Split System Air Conditioning in Melbourne
Professional electrical installation for all split system brands — single, multi and ducted configurations. We handle the power, the isolation and the switch wiring for a clean, compliant setup.
Single & Multi-Split Systems
A split system air conditioner needs a dedicated electrical circuit with an approved isolator switch within sight of the outdoor unit. We install the full electrical connection from switchboard to wall outlet, including the isolation point the installer requires.
Multi-split systems (two or more indoor units on one outdoor unit) need careful load assessment and circuit planning. We ensure your switchboard can handle the combined draw before installation begins.
What We Handle
We provide the complete electrical side of your split system install:
- Dedicated power circuit – new circuit from switchboard to wall outlet point
- Isolator switch – mandatory disconnection point within sight of the outdoor unit
- Switch wiring – wall switch or ceiling rose wired for thermostat or remote control
- Switchboard assessment – load check to confirm your board can handle the additional draw
- Compliance certification – all work tested and certified to AS/NZS 3000
Energy Efficiency & Star Ratings
Modern split systems are remarkably efficient. When choosing a unit, look for the energy star rating — higher is better. A 5-star rated system can use up to 50% less electricity than a 2-star model for the same cooling output.
We can advise on the right capacity for your space — oversized units cycle on and off wastefully, while undersized units run constantly and struggle to reach comfort temperature.
What to Expect
Frequently Asked Questions
Do I need a new circuit for my split system?
Will my switchboard handle a new split system?
How much does electrical installation cost?
Premium Service,
Quality Results,
Since 1963.
Over 63 years of trusted service across Melbourne
